CTS-D Questions PDF [2026] Use Valid New dump to Clear Exam [Q88-Q104]

Q88. What is the primary goal of a needs analysis?
Response:

Q89. According to best practices what is the safe working load (SWL) requirement for overhead mounting of a 75 pound (33.75 kg) projector?
Response:

Q90. According to best practices, what is the safe working load (SWL) requirement for overhead mounting of a 75 lb (34 kg) projector?
Response:

Q91. What other type of light, besides light coming directly from a source, must be measured?
Response:

Q92. Calculating for loudspeaker coverage takes into account which of the following?
Response:

Q93. A conference room is 40 ft. x 30 ft. and the ceiling is 10 ft. high. Ceiling loudspeakers will be used to cover the room for speech reinforcement with a target SPL level of 75 dB SPL.
The loudspeakers have a coverage circle diameter of 12 ft. and the spacing between loudspeakers is approximately 8.5 ft. Assuming the ceiling mounted loudspeakers are part of 70 V distributed system, what is the minimum size power amplifier that should be used?
Loudspeaker Sensitivity: 91 dB SPL @ 1 W / 1 m Transformer Taps available: 70 V: 60 W, 30 W, 15 W, 7.5 W 100 V: 60 W, 30 W, 15 W Response:

Q94. What type of drawing is displayed below?

Response:

Q95. Which of the following best describes a “matrix switcher”?

Q96. During the design phase of a project that has many network-enabled AV devices. What will the IT team need from the AV designer?
Response:

Q97. Which of the following best describes “RTSP” in video streaming?

Q98. PAG and NAG are important calculations for ensuring an audio system is:
Response:

Q99. Which of the following is a common method for controlling ambient noise in AV system design?

Q100. Which of the following describes a “floor plan” in AV design?

Q101. Two 6500 lumen projectors are being installed for a dual projection system. Each projector draws 1050 watts. What is the expected Btu output of both projectors?
Response:

Q102. In project documentation, a “block diagram” is used to show:

Q103. How do you determine the client’s long-term plans and needs in terms of equipment and support maintenance?
Response:

Q104. What type of drawing is pictured below?

Response: