Free Jul-2025 NSE7_EFW-7.2 Dumps are Available for Instant Access [Q19-Q41]

NO.19 Which statement about ADVPN is true?

lt only uses BGP for dynamic routing

It requires all the devices must be on the same AS for inter-region ADVPN topology

lt is a combination of hub-and spoke and full-mesh topologies

It supports only on single hub-and spoke architecture

NO.20 Exhibit.

Refer to the exhibit, which shows an ADVPN network.
The client behind Spoke-1 generates traffic to the device located behind Spoke-2.
Which first message floes the hub send to Spoke-110 bring up the dynamic tunnel?

Shortcut query

Shortcut reply

Shortcut offer

Shortcut forward

NO.21 Which two statements about IKE vision 2 are true? (Choose two.)

Phase 1 includes main mode

It supports the extensible authentication protocol (EAP)

It supports the XAuth protocol.

It exchanges a minimum of four messages to establish a secure tunnel

NO.22 Which two statements about the Security Fabric are true? (Choose two.)

FortiGate uses the FortiTelemetry protocol to communicate with FortiAnalyzer

Only the root FortiGate sends logs to FortiAnalyzer

Only FortiGate devices with configuration-sync set to default receive and synchronize global CMDB objects that the root FortiGate sends

Only the root FortiGate collects network topology information and forwards it to FortiAnalyzer

NO.23 Exhibit.

Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.
Which two conclusions can you draw from this con figuration? (Choose two)

10.1.5.254 is the default gateway of the internal network

On failover new primary device uses the same MAC address as the old primary

The VRRP domain uses the physical MAC address of the primary FortiGate

By default FortiGate B is the primary virtual router

NO.24 Refer to the exhibit, which contains a partial policy configuration.

Which setting must you configure to allow SSH?

Specify SSH in the Service field.

Select an application control profile corresponding to SSH in the Security Profiles section.

Include SSH in the Application field.

Configure port 22 in the Protocol Options field.

NO.25 Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

The router are in the number to match the remote peer.

You must change the AS number to match the remote peer.

BGP is attempting to establish a TCP connection with the BGP peer.

The bfd configuration to set to enable.

NO.26 Which statement about network processor (NP) offloading is true?

When NP acceleration is enabled, firewall sessions may not offload if proxy-based security profiles are included in the firewall policy.

You can disable the NP for each firewall policy using the command np-acceleration set to loose.

The FortiGate CPU offloads all firewall sessions that require FortiOS session helper to the network processing unit (NPU).

For UDP traffic, the FortiGate CPU offloads the first packet to identify it as fast-path traffic.

NO.27 You want to block access to the website ww.eicar.org using a custom IPS signature. Which custom IPS signature should you configure?

F-SBID ( –name “detect_eicar”; –protocol udp; –service ssl; –flow from_client; –pattern
“www.eicar.org”; –no_case; –context host;)

F-SBID ( –name “eicar”; –protocol udp; –flow from_server; –pattern “eicar”; –context host;)

F-SBID ( –name “detect_eicar”; –protocol tcp; –service dns; –flow from_server; –pattern “eicar”; –
-no_case;)

F-SBID ( –name “eicar”; –protocol tcp; –service HTTP; –flow from_client; –pattern
“www.eicar.org”; –no_case; –context host;)

NO.28 Winch two statements about ADVPN are true? (Choose two)

auto-discovery receiver must be set to enable on the Spokes.

Spoke to-spoke traffic never goes through the hub

lt supports NAI for on-demand tunnels

Routing is configured by enabling add-advpn-route

NO.29 Refer to the exhibit, which contains a partial VPN configuration.

What can you conclude from this configuration1?

FortiGate creates separate virtual interfaces for each dial up client.

The VPN should use the dynamic routing protocol to exchange routing information Through the tunnels.

Dead peer detection s disabled.

The routing table shows a single IPSec virtual interface.

NO.30 Winch two statements about ADVPN are true? (Choose two)

auto-discovery-receiver must be set to enable on the spokes

Spoke to-spoke traffic never goes through the hub

lt supports NAI for on-demand tunnels

Routing is configured by enabling add-advpn-route

NO.31 Exhibit.

Refer to the exhibit, which contains a partial policy configuration.
Which setting must you configure to allow SSH?

Specify SSH in the Service field

Configure pot 22 in the Protocol Options field.

Include SSH in the Application field

Select an application control profile corresponding to SSH in the Security Profiles section

NO.32 Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Set route-overlap to allow.

Set single-source to enable

Set route-overlap to either use-new or use-old

Set net-device to enable

NO.33 Refer to the exhibit, which provides information on BGP neighbors.

What can you conclude from this command output?

You must change the AS number to match the remote peer.

BGP is attempting to establish a TCP connection with the BGP peer.

The bfd configuration is set to enable.

The routers are in the same area ID of 0.0.0.0.

NO.34 Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.
Which two parameters must you set in the BGP configuration? (Choose two)

ebgp-enforce-multihop

recursive-next-hop

ibgp-enfoce-multihop

update-source

NO.35 Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Set route-overlap to allow.

Set single-source to enable

Set route-overlap to either use-new or use-old

Set net-device to enable

NO.36 Exhibit.

Refer to exhibit, which shows a central management configuration
Which server will FortiGate choose for web filler rating requests if 10.0.1.240 is experiencing an outage?

Public FortiGuard servers

10.0.1.242

10.0.1.244

10.0.1.243

NO.37 Refer to the exhibit, which contains a partial OSPF configuration.

What can you conclude from this output?

Neighbors maintain communication with the restarting router.

The restarting router sends gratuitous ARP for 30 seconds.

FortiGate restarts if the topology changes.

The router sends grace LSAs before it restarts.

NO.38 You created a VPN community using VPN Manager on FortiManager. You also added gateways to the VPN community. Now you are trying to create firewall policies to permit traffic over the tunnel however, the VPN interfaces do not appear as available options.

Create interface mappings for the IPsec VPN interfaces before you use them in a policy.

Refresh the device status using the Device Manager so that FortiGate populates the IPSec interfaces

Configure the phase 1 settings in the VPN community that you didnt initially configure. FortiGate automatically generates the interfaces after you configure the required settings

install the VPN community and gateway configuration on the fortiGate devices so that the VPN interfaces appear on the Policy Objects on fortiManager.

NO.39 Which two statements about IKE version 2 fragmentation are true? (Choose two.)

IKEv2 fragmentation is performed at IP layer.

The reassembly timeout default value is 30 seconds.

Only some IKE version 2 packets are considered fragmentable.

The maximum number of IKE version 2 fragments are 64.

NO.40 Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi-access network is true?

Only the DR receives link state information from non-DR routers.

Non-DR and non-BDR routers form full adjacencies to DR only.

FortiGate first checks the OSPF ID to elect a DR.

Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.

NO.41 Refer to the exhibit, which shows an ADVPN network,

An administrator must configure an ADVPN using IBGP and EBGP to connect overlay network 1 with 2.
What must the administrator configure in the phase 1 VPN IPSEC configuration of the Hub2¢ub tunnels?

set auto-discovery-sender enable

set auto-discovery-forwarder enable

set add-route enable

set auto-discovery-receiver enable

Free Jul-2025 NSE7_EFW-7.2 Dumps are Available for Instant Access [Q19-Q41]

NSE5_FAZ-7.0 Dumps 2023 – New Fortinet NSE5_FAZ-7.0 Exam Questions [Q39-Q60]

Verified FCP_FAZ_AD-7.4 &As – Provide FCP_FAZ_AD-7.4 with Correct Answers [Q85-Q104]

TestBraindump NSE6_FML-6.2 Exam Questions Real NSE6_FML-6.2 Practice Dumps [Q30-Q46]

Leave a Reply Cancel reply

Related Posts

Leave a Reply Cancel reply