H3C GB0-191-ENU Daily Practice Exam New 2023 Updated 434 Questions [Q215-Q230]

Rate this post

H3C GB0-191-ENU Daily Practice Exam New 2023 Updated 434 Questions

Use Valid GB0-191-ENU Exam – Actual Exam Question & Answer

QUESTION 215
There is a default route in the router’s routing table, its destination network segment and mask are both 0.0.0.0, and its next hop is the router’s S0/0 interface, then the following description of this route is correct. ______. (Multiple choice)

 
 
 
 

QUESTION 216
The IP address 10.0.10.65 and the mask 255.255.255.224 represent a ______.

 
 
 
 

QUESTION 217
The two routers RTA and RTB are interconnected back-to-back using serial ports. The serial port of RTA is configured with HDLC protocol, and the serial port of RTB is configured with PPP protocol.
Both devices are configured with the correct IP address, then what will happen is ______. (Multiple choice)

 
 
 
 
 

QUESTION 218
Which of the following statements about IP addresses are correct is ______. (Multiple choice)

 
 
 
 

QUESTION 219
After opening the console to monitor system information, use the ______ command to turn on the screen output of debugging information.

 
 
 
 

QUESTION 220
On the MSR router, if you want to specify the source address of the message sent during the ping operation, you should use the ______ parameter.

 
 
 
 

QUESTION 221
A company purchased switches from two manufacturers, A and B, for network engineering implementation. Need to use link aggregation technology between the switches of the two vendors. After consulting the relevant documents, it is found that the switch of manufacturer A does not support the LACP protocol.
In this case, which of the following configuration methods are reasonable? (multiple choice)

 
 
 
 
 

QUESTION 222
As shown in the figure, the three MSR routers run OSPF and RIP respectively.

Now that the OSPF neighbor status between RTA and RTB is stable, and the RIPv2 between RTB and RTC is also working normally, then within 40 minutes from this moment, ______. (Multiple choice)

 
 
 
 

QUESTION 223
Use the ______ command on the MSR series router to display the current path of the file system.

 
 
 
 

QUESTION 224
The command to configure the interface Ethernet1/0/1 on the switch SWA as an edge port is ______.

 
 
 
 

QUESTION 225
The user router S0/0 is connected to the frame relay network, and the following information is displayed on the interface of the router: Serial1/1 current state:UP Line protocol current state:DOWN Internet Address is 3.3.3.2/24 The protocol state of the interface is DOWN, Then analyze ______ accordingly.

 
 
 
 

QUESTION 226
A DNS client queries the local domain name server for the IP address of www.sina.com.cn, and the local domain name server usually responds by means of DNS query?

 
 
 
 

QUESTION 227
The role of link aggregation is ______.

 
 
 
 

QUESTION 228
Which of the following statements about optical fiber is wrong? (multiple choice)

 
 
 
 

QUESTION 229
On the MSR router, if you want to view the number of packets translated by NAT, you should use the ______ command.

 
 
 
 

QUESTION 230
The command to start the spanning tree protocol on the switch is ____.


Test Engine to Practice GB0-191-ENU Test Questions: https://www.testbraindump.com/GB0-191-ENU-exam-prep.html

Related Links: myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt myportal.utt.edu.tt www.stes.tyc.edu.tw www.stes.tyc.edu.tw

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below