[Q12-Q26] PASS H12-261_V3.0-ENU exam with Huawei Real Exam Questions – 100% Valid!

NO.12 Regarding routing control, which of the following description is correct? (Multiple choice)

NO.13 Which of the following configuration of OSPFv3 route aggregation is correct?

NO.14 The Next Header field information only exists in the IPv6 message and is used to indicate whether there is an extended header in IPv6.

NO.15 Which of the following description about the address resolution function of NDP is wrong?

NO.16 An existing switch runs the RSTP protocol. If the network topology changes, what will happen to the Layer 2 forwarding entries automatically learned by the switch?

NO.17 Run the display mpls Isp command on the router to view the LSP information. The command output is as follows.
Which of the following is correct?

NO.18 Which AS_PATH can the command ip as-path-filter1 permit^12*74$ match?

NO.19 Regarding the configuration of the security level of the firewall security zone, which of the following statement is wrong?

NO.20 What are the wrong statements about OSPF Router LSA and Network LSA? (Multiple questions)

NO.21 Router R1 runs the 0SPF protocol. Use the display ip routing-table command to view the routing table of the Router R1. Which of the following description is correct about the 0SPF information in the routing table?

NO.22 During the evolution from IPv4 network to IPv6, some transition technologies have emerged. Which of the following are common types of transition technologies? (Multiple questions)

NO.23 Which of the following statement about OSPF routing calculation is incorrect?

NO.24 The two routers are connected through the serial port, but they cannot ping each other. Now check the port status as follows. Can you determine the cause from the above information?

NO.25 There are two Community-fiter:
ip communityfiter 1 pemit 100:1 200:1
ip community-filter 2 pemit 100:1
ip commmunityfiter2 pemit 200:1
Which of the following description about the above communityfite is correct? (Multiple choice)

NO.26 The Level-1-2 IS will send Level-2 LSPs to the level-1 IS Level-1 area in the domain. If the ATT position in the Level-2 LSP is 1, it means the area Access to the external area through level-1-2 IS.