[Q35-Q55] Ultimate Guide to Prepare 300-710 with Accurate PDF Questions [Jun 08, 2022]

NO.35 An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10
10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

NO.36 administrator is configuring SNORT inspection policies and is seeing failed deployment messages in Cisco FMC . What information should the administrator generate for Cisco TAC to help troubleshoot?

NO.37 Which CLI command is used to generate firewall debug messages on a Cisco Firepower?

NO.38 What is a valid Cisco AMP file disposition?

NO.39 An engineer currently has a Cisco FTD device registered to the Cisco FMC and is assigned the address of 10 10.50.12. The organization is upgrading the addressing schemes and there is a requirement to convert the addresses to a format that provides an adequate amount of addresses on the network What should the engineer do to ensure that the new addressing takes effect and can be used for the Cisco FTD to Cisco FMC connection?

NO.40 When do you need the file-size command option during troubleshooting with packet capture?

NO.41 An organization wants to secure traffic from their branch office to the headquarter building using Cisco Firepower devices, They want to ensure that their Cisco Firepower devices are not wasting resources on inspecting the VPN traffic. What must be done to meet these requirements?

NO.42 Which two packet captures does the FTD LINA engine support? (Choose two.)

NO.43 What is a result of enabling Cisco FTD clustering?

NO.44 An engineer is configuring a cisco FTD appliance in IPS-only mode and needs to utilize fail-to-wire interfaces.
Which interface mode should be used to meet these requirements?

NO.45 Refer to the exhibit An engineer is modifying an access control pokey to add a rule to inspect all DNS traffic that passes through the firewall After making the change and deploying the pokey they see that DNS traffic is not bang inspected by the Snort engine What is the problem?

NO.46 An engineer integrates Cisco FMC and Cisco ISE using pxGrid. Which role is assigned for Cisco FMC?

NO.47 Which license type is required on Cisco ISE to integrate with Cisco FMC pxGrid?

NO.48 Which Firepower feature allows users to configure bridges in routed mode and enables devices to perform Layer 2 switching between interfaces?

NO.49 Which command-line mode is supported from the Cisco Firepower Management Center CLI?

NO.50 Which Cisco Firepower rule action displays an HTTP warning page?

NO.51 An administrator is optimizing the Cisco FTD rules to improve network performance, and wants to bypass inspection for certain traffic types to reduce the load on the Cisco FTD. Which policy must be configured to accomplish this goal?

NO.52 An organization has implemented Cisco Firepower without IPS capabilities and now wants to enable inspection for their traffic. They need to be able to detect protocol anomalies and utilize the Snort rule sets to detect malicious behaviour. How is this accomplished?

NO.53 A Cisco FTD has two physical interfaces assigned to a BVI. Each interface is connected to a different VLAN on the same switch. Which firewall mode is the Cisco FTD set up to support?

NO.54 administrator is configuring SNORT inspection policies and is seeing failed deployment messages in Cisco FMC . What information should the administrator generate for Cisco TAC to help troubleshoot?

NO.55 Drag and drop the steps to restore an automatic device registration failure on the standby Cisco FMC from the left into the correct order on the right. Not all options are used.