Real NSE6_FSW-7.2 dumps Accurate Questions and Answers with Free and Fast Updates [Q19-Q35]

NO.19 Exhibit.

You need to manage three FortiSwitch devices using a FortiGate device. Two of the FortiSwitch devices initiated a reboot after the authorization process. However, the FortiSwitch device with the configuration shown in the exhibit. did not reboot All three devices completed FortiLink manage-ment authorization successfully.
Why did the FortiSwitch device shown in the exhibit not reboot to complete the authorization pro-cess?
The management mode was set to use FortiLink mode.

NO.20 What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?

NO.21 Refer to the exhibit.

Which two statements best describe what is displayed in the FortiLink debug output shown in the exhibit? (Choose two.)

NO.22 Which two statements about DHCP snooping enabled on a FortiSwitch VLAN are true? (Choose two.)

NO.23 Exhibit.

Two routes are not installed in the forwarding information base (FIB) as shown in the exnibit. Which two statements about these two route entries are true? (Choose two.)

NO.24 Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?

NO.25 What are two reasons why time synchronization between FortiGate and its managed FortiSwitch is critical in switch management? (Choose two.)

NO.26 Exhibit.

port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the management interface. Which two actions should you take to fix the issue and access FortiSwitch? (Choose two.)

NO.27 Which statement about the IGMP snooping querier when enabled on a VLAN is true?

NO.28 Refer to the exhibits


Traffic arriving on port2 on FortiSwitch is tagged with VLAN ID 10 and destined for PC1 connected on port1. PC1 expects to receive traffic untagged from port1 on FortiSwitch.
Which two configurations can you perform on FortiSwitch to ensure PC1 receives untagged traffic on port1? (Choose two.)

NO.29 Refer to the exhibit.
The profile shown in the exhibit is assigned to a group of managed FortiSwitch ports. and these ports are connected to endpoints which are powered by PoE. Which configuration action can you perform on the LLDP profile to cause these endpoints to exchange PoE information and negotiate power with the managed FortiSwitch?

NO.30 Which QoS mechanism maps packets with specific CoS or DSCP markings to an egress queue?

NO.31 FortiGate is unable to establish a tunnel with the FortiSwitch device it is supposed to manage Based on the debug output shown in the exhibit, what is the reason for the failure?

NO.32 Which feature should you enable to reduce the number or unwanted IGMP reports processed by the IGMP querier?

NO.33 Refer to the diagnostic output:

What makes the use of the sniffer command on the FortiSwitch CLI unreliable on__port__23?

NO.34 Exhibit.

port1 and port2 are the only ports configured with the same native VLAN 10.
What are two reasons that can trigger port1 to shut down? (Choose two.)

NO.35 Refer to the diagnostic output:

Two entries in the exhibit show that the same MAC address has been used in two different VLANs. Which MAC address is shown in the above output?